Heckler & Koch P30 (V1)

WHY THIS CATALOGUE NUMBER: HK's page lists it first under "P30 Pistols, 9mm", and it carries HK's own variant number 1 — HK designates no base configuration in words, so first-listed V1 is the base on the maker's own ordering. This matters more than usual, because the page's specification block does NOT describe this SKU (below). Separate listings under the base-model rule: the other three V1 catalogue numbers (81000105 with two 10-round magazines, 81000104 and 81000106 with night sights), the V3 DA/SA configurations 81000107–81000110, the P30S 81000111–81000114, the .40 S&W P30S 81000127–81000129, and the P30L and P30SK, which have their own pages. Sourced from Web Archive captures of hk-usa.com, which serves a Cloudflare interstitial to every request (re-checked 2026-09-30); every capture was content-checked. Live product, as-published at 2025-02-16. THE PRODUCT PAGE'S SPECIFICATION BLOCK DESCRIBES A DIFFERENT TRIGGER, AND ITS TRIGGER FIGURES ARE NOT RECORDED. It reads "Trigger system: SA/DA" and "Trigger pull (N): 20 + 4/-2 (SA) 51 +/- 5 (DA)", while this catalogue number is a V1 LEM, which the same page describes as HK's "enhanced double action only Law Enforcement Modification (LEM) trigger" and which has no single-action mode at all. The block designates no variant; its figures fit the V3 DA/SA listings. Recording them here would put a DA/SA pair on a DAO pistol. The V1 figure comes instead from HK's archived P30 Series operator's manual, which tabulates trigger pull per variant (p. 9): "Variant 1 (V1) 18 N - 27 N" and "4.05 - 6.07" pounds, both approximate and both published, so nothing is converted. The manual's V3 row (18–27 N single action, 56 N after decock) does not match the page's V3-looking 20/51 N either — a second disagreement between the two documents, noted because it is evidence about the block rather than because it touches this record. TRIGGER ACTION IS `dao` ON HK'S OWN WORDS, AND THE MECHANISM IS NOTED RATHER THAN RECLASSIFIED. The manual's variant key defines "Variant 1 (V1) Light trigger pull, Law Enforcement Modification (LEM) enhanced DAO" (p. 8), and `system` quotes it. HK's product page also describes the LEM as combining "a cocked striker component" with "a double-action hammer system" — a pre-cocked design, the same family as CZ's "SFDA" — but HK itself classifies it as double action only, so this follows the published label (the TaurusTX 22 rule) rather than reasoning from the mechanism. CAPACITY FOLLOWS THE SKU; THE SPEC BLOCK DISAGREES. The block says "Magazine capacity: 15 Rounds", while catalogue number 81000103 ships two 17-round magazines, so 17 is standard (the FN 509 and VP9 handling) and the block's 15 is recorded as the optional figure the page publishes. The manual lists "20, 17, 15 or 10 rounds" (p. 8) and the page's parts table lists a 20-round VP9/P30 magazine; neither is recorded, because the capacity row is footnoted to the product page, whose specification block names only 15 (the GX4 rule). IGNITION AND OPERATING SYSTEM COME FROM THE MANUAL. "Operating Principle: Short recoil, modified" (p. 8) is the operating-system axis in HK's words. The ignition rests on the manual's cycle-of-operation description rather than a one-line classification — the sear releases "the hammer (DA/SA variant) or cocking piece (LEM variant)", "allowing the hammer strut spring to pivot the hammer forward with enough energy to strike the firing pin" (p. 10), and the drop-safety section repeats that for LEM variants the sear releases the cocking piece, "allowing the hammer to swing forward and strike the back of the firing pin" (p. 12). Both passages name the LEM explicitly, which is what makes them citable for this variant; no single sentence says "hammer-fired", and the page's "Bobbed hammer (LEM models)" feature line is a component and was not relied on. THE MANUAL USED IS THE ONE HK LINKED FROM THIS PAGE IN AUGUST 2024 (P30-Series-Operators-Manual.pdf, created January 2024); the February 2025 page links a renamed "-1.pdf" that the archive never captured, so whether it differs is unknown. MANUAL AND PAGE DISAGREE ONLY AT ROUNDING LEVEL ON THE DIMENSIONS, and the current page governs: length 7.12 in (page) against 7.13 in (manual), both 181 mm; barrel 3.85 in against 3.86 in, both 98 mm; weight 740 g / 26.08 oz (page, "With magazine") against 739 g / 26.07 oz (manual, "with empty magazine"). 181 mm is 7.126 in and 98 mm is 3.858 in, so the page truncates where the manual rounds. The page's 740 g and 26.08 oz are 1 g apart. Year introduced is 2007, from HK's own statement "The P30 (introduced in 2007)" inside the release announcing the P30L — not a P30 launch release, and the release body carries no dateline (its URL encodes October 28, 2008); HK does not say whether 2007 refers to Europe or the US. Frame class is unset — HK publishes none. HK publishes a "P30 Series" (hk-usa.com/hk-series/p30-series/), not in the `Family` union, so `family` is unset pending a user decision. HK's international site (heckler-koch.com) publishes a P30 page with "Operating Principle: Recoil-Operated", but calls its triggers "CDA" rather than LEM and gives the V1 "approx. 24 N" against the US manual's 18–27 N, so it is not used — the VP9/SFP9 naming rule, arriving here as a trigger name rather than a model name. Also published and unrecorded for want of a schema field: a 148.5 mm / 5.84 in sight radius, a 250 mm twist, a six-sided polygonal bore, a nitro-carburized slide with a "hostile environment" blued finish, a lock-out safety device and the $839 MSRP.